Door adjustment

[HeyAndy]

Any tips on adjusting the doors. Since replacing my outriggers the doors don't close as cleanly as they used to do. I think they were being held on by the body as opposed to the sill plate supporting the door upright.

[wedg1e]

Andy:
You can adjust the striker on the body, and also the door on its frame.
Should be plenty of adjustment range, it's just a matter of slightly slackening things*, moving door to where you think it should be then tightening up.

In theory

*The lock mechanism has some movement on the frame when you slacken its mounting screws. Near to the lock are a couple of domed-head screws, also there are a couple of bolts at the front edge of the door. These are the mounting points.

Ian

[HeyAndy]

Thanx Ian I'll try moving things about a bit, can't believe the difference in movement though.

[350zwelgje]

If you need more information, have a look at the wedgepages www.tvrwedgepages.co.uk
Mike has published information on this in the maintenance section (if I am not wrong).

Rob

[shpub]

Also covered in the bible as well.