central consol/trim

[degz]

I am going to try and remove the trim from top of the drive tunnel, the long bit between the seats, does anyone know where the bolts/screws are? anyone already taken thiers off? easy?
also look at
www.pistonheads.com/gassing/topic.asp?t=97725&f=66&h=0
its so I can change the gear box on my 200. all advice welcome.

[wedg1e]

Prise out the padded bottom of the tray to the rear of the tunel. Hiding under the vinyl will be a screw or two.
You'll need to dismantle half the centre (radio) console as well in order to get enough height to lift the centre cover out.
Bit of wrestling with the handbrake and gear lever gaiters as well. Nothing too drastic

Ian

[jvaughan]

Good luck. I want to change the gearstick gator on my 400SE, but gave up in the end

[york33]

only ones on mine are at the front of the tunnel into the centre console. Remove the padded centre console by undoing the two bolts, one either side and the two bolts on the end of the long tunnel top bit should be revealed. All these Wedges are different so hopefully one of the suggested ways will help

cheers
Dave