Wedge misfire
Wedge misfire
Author
Discussion

racingsnake

Original Poster:

1,071 posts

254 months

Wednesday 17th August 2005
quotequote all
Oh no! the wedge (350i 1989)has developed a misfire, at low revs as i apply load to accelarate. It will clear as revs build but struggles to tick over once warm and once it stalls it wont restart till its cooled down just cranks over flooding.
Any of you Guru's got any ideas.
Have checked HT leads,LT leads,Dizzy cap, all visible connections I am stumped.
Oil is clean as is coolant and not using any water.
I was hoping to get the car to Blueflame for its new exhaust fitted but cant take the bugger anywhere now.
HELP!

dickymint

29,056 posts

287 months

Wednesday 17th August 2005
quotequote all
Possibly the ignition module breaking down - black box of trickery bolted to the distributor. Typical problem with these is it wont start when engine is hot.

racingsnake

Original Poster:

1,071 posts

254 months

Wednesday 17th August 2005
quotequote all
Thanks mate, were would i get one and is it just a bolt on jobby or does it need setting up?

Is it the box on the side of the dizzy with two spade connectors on the top? Any ideas how much?

Gandalf

2,381 posts

267 months

Wednesday 17th August 2005
quotequote all
Had self same symptoms a few weeks back from cold for about 3 miles all was normal then as it warmed up the car would be as lumpy as ****** below 2500 but above 3000 was as normal it appeared as if it was overfuelling once warmed up.
After 3 days of diagnostic treatment (plugs, points leads etc etc.) it was discovered that the throttle butterfly potentiometer was giving spurios voltage readings - they replaced it with a new item and all has been rosy ever since-until I broke the front shocks!

Hope this may be of some help, good luck

dickymint

29,056 posts

287 months

Wednesday 17th August 2005
quotequote all
racingsnake said:
Thanks mate, were would i get one and is it just a bolt on jobby or does it need setting up?

Is it the box on the side of the dizzy with two spade connectors on the top? Any ideas how much?


They're about £70. No setting just bolt on. I would suggest you find someone near you with a Wedge and try a swap first. Tim at ACT Products sells em

honestjohn

1 posts

253 months

Wednesday 17th August 2005
quotequote all
i see dickymint wrote a book on rover v8 injection systems.... why not ask him....he's really clever