what is it ?
what is it ?
Author
Discussion

andy390se

Original Poster:

318 posts

252 months

Friday 15th June 2007
quotequote all

any ideas looks a bit diy to me some cars have a grill over it some have the plastic but not cut out some cars dont have it at all.
is it to let fumes in to the cabin or just water?
any awnsers or should i just block it up?


djc1001

490 posts

275 months

Friday 15th June 2007
quotequote all
Mine doesn't have anything like this but seen a wedge recently with a mesh grill in the rear lip of the bonnet (high pressure area) and a box which joined to the intake you show. - therfore 'fresh' air to the back of the heater - there was a drain arrangement at the bottom of the piece you show.
Good idea in principle - interesting if anybody has actually made them work without filling the car with water.
r's
david

James MK

556 posts

280 months

Friday 15th June 2007
quotequote all
Yup, that's the heater intake. Mine works just fine, always hot and always blowing.

andy390se

Original Poster:

318 posts

252 months

Friday 15th June 2007
quotequote all
heater intake my heater works fine too it just seems to be to open to the elements was thinking about blocking up and cutting some small hoes in the front or the plastic?
james mk looked at your profile nice car not parked in dulich village are you?

adam quantrill

11,679 posts

271 months

Friday 15th June 2007
quotequote all
Don't do it!

If you look at the mating face on the bonnet you'll see some foam that goes around that hole.

This is to seal out the engine bay smells so the air gets sucked in from the windscreen side.

If you ever had an exhaust leak you would get CO in the cabin, without the foam in place, or drilling holes etc....

- Adam

andy390se

Original Poster:

318 posts

252 months

Friday 15th June 2007
quotequote all
thanks for the advice adam.
do you rember me coming to view your 350i about a year ago?

James MK

556 posts

280 months

Friday 15th June 2007
quotequote all
andy390se said:
heater intake my heater works fine too it just seems to be to open to the elements was thinking about blocking up and cutting some small hoes in the front or the plastic?
james mk looked at your profile nice car not parked in dulich village are you?
Well spotted! And you didn't you have a drive in it round the Woodman last autumn?

andy390se

Original Poster:

318 posts

252 months

Friday 15th June 2007
quotequote all
no never driven it.
dulich village is the only place i know that has white fencing and chains near the road.
should of been a detective!
do you mean the woodman pub for the surrey monthly meet i hope to be going to the next one , been having a few probs lately but seems to running fine now .

gwood

203 posts

242 months

Friday 15th June 2007
quotequote all
my 350i has a mesh over it with the washer jets in it, but the bonnet has a vent in it too on the inside near the wiper for getting air into it.

blaineuk

2,615 posts

276 months

Friday 15th June 2007
quotequote all
my 390 didn't have a hole so i cut one, the heater blower was a lot better after this.

James MK

556 posts

280 months

Friday 15th June 2007
quotequote all
andy390se said:
no never driven it.
dulich village is the only place i know that has white fencing and chains near the road.
should of been a detective!
do you mean the woodman pub for the surrey monthly meet i hope to be going to the next one , been having a few probs lately but seems to running fine now .
I tend to go the woodman for the odd pistonheads meet, but only when the car's going, hence not been for a while. And yes, dulwich is distinctive!