Rusty Bolts
Author
Discussion

Bezerk

Original Poster:

475 posts

190 months

Wednesday 12th November 2025
quotequote all
Can anyone advise on the correct steps to sort these?
I have touch up paint already so I was thinking rust converter > clean up > repaint.

I am missing anything or totally wrong? Thanks


steveo3002

11,244 posts

205 months

Wednesday 12th November 2025
quotequote all
remove and fit stainless ones if its bothering you ?

or remove one at a time and wire wheel it clean , prime and paint

anonymous-user

85 months

Wednesday 12th November 2025
quotequote all
I'd take one bolt out at a time so as not to disturb the fitment, clean up with a wire brush on a drill,prime and paint....if you want you can bolt it back in before you put the top coat on so as not to risk damaging the paint

mike9009

11,024 posts

274 months

Saturday 22nd November 2025
quotequote all
steveo3002 said:
remove and fit stainless ones if its bothering you ?

or remove one at a time and wire wheel it clean , prime and paint
I would go stainless. As soon as you try torquing them again it will remove/ damage the paint. Back at square one again.....

InitialDave

15,201 posts

150 months

Saturday 22nd November 2025
quotequote all
For that specific situation, I'd shield the surrounding components so as not to scuff anything, clean up the rust with a very small wire brush, then use rust converter and touch up.

I dont see a need to remove the bolts or replace with stainless ones.

steveo3002

11,244 posts

205 months

Saturday 22nd November 2025
quotequote all
can get plastic covers if theyre offending you

markymarkthree

3,717 posts

202 months

Saturday 22nd November 2025
quotequote all
Remove bolt, remove rust, replace bolt.
Repeat above with 2nd bolt.
Paint both bolts in situ. smile