Pioneer CD/radio dismantling the front?
Pioneer CD/radio dismantling the front?
Author
Discussion

Skyedriver

Original Poster:

23,707 posts

313 months

Saturday 7th November
quotequote all


Following on from my previous quest, I'm looking to remove the black plastic front from a Pioneer CD/radio to try and create a plate over the too large hole in the dash.
I'm thinking the 4 small "Phillips" screws and the front will come off? Don't need to remove the unit itself, just the plastic front. Any one able to confirm please




InitialDave

15,191 posts

150 months

Saturday 7th November
quotequote all
I think you're best to remove the head unit and try to do what you want on a bench.

But I'm not going to go doing shovel work around the forums to find out, so what's the underlying issue you're wanting to deal with?

Skyedriver

Original Poster:

23,707 posts

313 months

Saturday 7th November
quotequote all
hi Dave, been trawling the internet for videos, seems like the surround is separate and should just pop off? I was looking and thought the surround was part of the unit itself. Will head back out in the cold for further investigation. I'm wanting to mask or fill the gap down the right hand side and across the top.

InitialDave

15,191 posts

150 months

Saturday 7th November
quotequote all
In my experience, yes, most single DIN trim surrounds are clipped onto the body of the head unit itself, as they block access to getting the tools down the side for removal, but it can be annoying trying to figure out where the clips are.

However, it looks like yours may have a gap specifically for a removal tool either side, and so could be a one piece moulding?




Skyedriver

Original Poster:

23,707 posts

313 months

Saturday 7th November
quotequote all
Yes I've two or three sets of removal tools couldn't get the thing loose. Must try harder (like my old school report)

InitialDave

15,191 posts

150 months

Saturday 7th November
quotequote all
Skyedriver said:
Yes I've two or three sets of removal tools couldn't get the thing loose. Must try harder (like my old school report)
If it doesn't work in a way that ties into what's already installed, is replacing the head unit entirely a viable option?

Skyedriver

Original Poster:

23,707 posts

313 months

Wednesday 11th November
quotequote all
Finally wangled the unit out the dash, yes the surround and front are one, no separate bezel. Have made a surround from 1.5mm thick plastic to cover the hole. In retrospect something thicker would have looked more "original", the plastic is shiny black the dash & radio matt/satin grey.

InitialDave

15,191 posts

150 months

Wednesday 11th November
quotequote all
Skyedriver said:
Finally wangled the unit out the dash, yes the surround and front are one, no separate bezel. Have made a surround from 1.5mm thick plastic to cover the hole. In retrospect something thicker would have looked more "original", the plastic is shiny black the dash & radio matt/satin grey.
Get some Plasti-Dip style paint (spray on wrap, effectively), it does an excellent job of looking like moulded plastic for jobs like this.

simon_harris

3,250 posts

65 months

Thursday 12th November
quotequote all
you can get the same effect with normal paint, after the initial coat you kind of sputter the can to get the plastic texture effect, used to do it all the time when supplying GRP gauge pods.