Suspension Pivot Bearings
Suspension Pivot Bearings
Author
Discussion

benny.c

Original Poster:

3,805 posts

238 months

Thursday 12th November
quotequote all
I need to replace the lower pivot bearings on my Bronson and just wondering where everyone buys theirs from. I usually use Aire Velo for headset bearings and have no complaints but not used their frame bearings. Prices are broadly similar from various sources at around £50 per set. Any recommendations are welcome.

BOR

5,154 posts

286 months

Thursday 12th November
quotequote all
Are you the first owner?

If you register with Santa Cruz, they send you the pivot bearing kit for free.

TGCOTF-dewey

8,029 posts

86 months

Thursday 12th November
quotequote all
I will generally check out commercial bearing supplies and buy from whoever is cheapest that week for SKF/NTN etc.

Often simply bearings.

bmwmike

8,803 posts

139 months

Thursday 12th November
quotequote all
Max fill enduro for my full suss, from wherever is cheapest at the time.

benny.c

Original Poster:

3,805 posts

238 months

Thursday 12th November
quotequote all
Thanks all.

BOR said:
Are you the first owner?

If you register with Santa Cruz, they send you the pivot bearing kit for free.
Unfortunately not.

POIDH

3,932 posts

96 months

Thursday 12th November
quotequote all

benny.c

Original Poster:

3,805 posts

238 months

Thursday 12th November
quotequote all
Cheers. I don’t suppose you can go too wrong so long as you avoid the really cheap non-branded stuff.

P-Jay

11,428 posts

222 months

Tuesday
quotequote all
benny.c said:
Cheers. I don t suppose you can go too wrong so long as you avoid the really cheap non-branded stuff.
Yeah, stick to branded ones from decent suppliers. I use

https://www.wychbearings.co.uk/?gad_source=1&g...

And generally stick to Enduro branded ones.

There are incremental gains if you know about loadings and stuff. Do SC still use the grease gun port? You may need bearings with only one rubber sealed side but check. That said, personally I don't think that system is enough for UK riding and always used 2RS bearings on my linkages.

benny.c

Original Poster:

3,805 posts

238 months

Tuesday
quotequote all
I went with Kinetic in the end. Ordered Thursday and arrived Friday with free postage so no complaints with the service.

Yes SC still have the grease port with no cover on one side of the bearing for the lower linkage. I've got a little thumb operated gun which I've fitted a standard Zerk coupling to for doing it. Not sure if it actually extends the bearing life but current set have been in for at least 12 months - I purchased the bike second hand so not sure how old they actually are. The lower non-drive side has developed a bit a play though.

Edited by benny.c on Tuesday 17th November 12:12