Bike Part Name
Bike Part Name
Author
Discussion

jrinns

Original Poster:

406 posts

213 months

Friday 20th September 2013
quotequote all
Hi all,

On my trip to italy last week a piece of metal dropped off my Cannondale Synapse, it was stuck on the bootom frame next to the crank , but I do not know what its called. Its obviously some type of frame guard.

Any one know the correct name?

Edited by jrinns on Friday 20th September 13:09

Disco You

3,749 posts

210 months

Friday 20th September 2013
quotequote all
If you mean crank and not "crack" was it a chain catcher?

jrinns

Original Poster:

406 posts

213 months

Friday 20th September 2013
quotequote all
edited thanks, its not a catcher, its on the part of the frame that runs from the crank to the rear wheel, and is just a protector of some sort

Jimbo.

4,231 posts

219 months

Friday 20th September 2013
quotequote all
Chainstay protector.

jrinns

Original Poster:

406 posts

213 months

Friday 20th September 2013
quotequote all
Not a chainstay protector, it was stuck onto the frame where is flares out from the Bottom Bracket and looks to protect the carbon in case the chain gets trapped between the crank and frame

ewenm

28,506 posts

275 months

Friday 20th September 2013
quotequote all
Was it there to prevent chain-suck (where the chain sticks to the chainring and is dragged up behind the bottom bracket)?

tuffer

9,012 posts

297 months

Friday 20th September 2013
quotequote all
I have the same thing on my Canyon, its an aluminium plate to protect the frame if the chain comes off (which mine did a few times and it actually took a gouge out of the plate). No idea what its called but your Cannondale dealer should be able to help.

ollie j

273 posts

191 months

Saturday 21st September 2013
quotequote all
This?
http://qwertycycles.co.uk/products/chainstay-prote...

It's still a chain stay protector, just a smaller metal one that is close to the BB rather than the other place you find them.

yellowjack

18,515 posts

196 months

Saturday 21st September 2013
quotequote all
tuffer said:
I have the same thing on my Canyon, its an aluminium plate to protect the frame if the chain comes off (which mine did a few times and it actually took a gouge out of the plate). No idea what its called but your Cannondale dealer should be able to help.
Pffff. I wish I'd had one of those on my GT Avalanche when it decided to pick the chain up and gouged a hole in the chainstay. My fault as I'd hit a rock and bent some teeth on the middle chain ring. These bent teeth then failed to release the side plates of the chain on the first revolution after changing onto the middle ring. Bike is still going, and has even done a couple of laps of Swinley's Red Trail, but confidence in the bike is now much lower than it ever was frown

jrinns

Original Poster:

406 posts

213 months

Sunday 22nd September 2013
quotequote all
ollie j said:
This?
http://qwertycycles.co.uk/products/chainstay-prote...

It's still a chain stay protector, just a smaller metal one that is close to the BB rather than the other place you find them.
Cheers. Thats the one, lost the last one on my stelvio tour