mk1 eunos import - rear number plate size

[WhiteBaron]

No picture at the minute - its dark, but the previous owner appears to have got the largest plate that fits in the gap and it rubs - both sides and against the bumper too not sure why someone would do this....


Anyway , what size should the plate be? if it helps/changes I only need a 6 digit plate.

thanks in advance

Steve

J-limited II

[Munter]

Near the bottom: https://www.craigsplates.com/standard-yellow-or-wh...

Never had one of those off them however.

Edit: Put it through as a show plate if you are using the plate builder to select the "Eunos" size.

Edited by Munter on Tuesday 6th November 21:01

[WhiteBaron]

Munter said:

Near the bottom: https://www.craigsplates.com/standard-yellow-or-wh...

Never had one of those off them however.

Edit: Put it through as a show plate if you are using the plate builder to select the "Eunos" size.

Edited by Munter on Tuesday 6th November 21:01

thankyou

[Eighteeteewhy]

Thread worth reading here...

http://www.pistonheads.com/gassing/topic.asp?h=...

Just in case you get pulled by your local friendly bobby.

[Jobbo]

Munter said:

Near the bottom: https://www.craigsplates.com/standard-yellow-or-wh...

Never had one of those off them however.

Edit: Put it through as a show plate if you are using the plate builder to select the "Eunos" size.

Edited by Munter on Tuesday 6th November 21:01

I had one from Craigsplates on my last Eunos - it's an exact fit. So much so that it was an absolute pain to remove when I sold the car and changed the plate back; use velcro rather than sticky pads!



Do bear in mind that Craigsplates won't make them with the BS markings unless you send them your original ID documents; mine didn't have markings because I wasn't willing to post my passport and V5.