Phone holders
Phone holders
Author
Discussion

Huzzah

Original Poster:

29,018 posts

213 months

Monday 21st April 2025
quotequote all
Any ideas? Ashtray cover is slightly convex so current suckered doesn't fit too well.

I want to infrequently use waze but don't want any damage to dashboard or trim..



This is where I'd like it



NDA

25,659 posts

255 months

Monday 21st April 2025
quotequote all
Something stuck on the windscreen rather than the dash? There are some very neat and small screen mounts around - particularly if your phone (or it's case) have a magnet.

trashbat

6,310 posts

183 months

Monday 21st April 2025
quotequote all
Where you've put it is too low IMO and more dangerous to look at than necessary. Show us the upper dash and air vents.

Huzzah

Original Poster:

29,018 posts

213 months

Monday 21st April 2025
quotequote all
It's a convertible so mounting it higher results in reflections.


I'm wary of damaging the vents.



Edited by Huzzah on Monday 21st April 18:05

Mandat

4,640 posts

268 months

Monday 21st April 2025
quotequote all
I've used something like this in the past, which clamps into the CD slot on your dash

https://www.amazon.co.uk/s?k=cd+slot+mount+car+pho...

kambites

71,548 posts

251 months

Monday 21st April 2025
quotequote all
Try mounting it higher (like on the vents) but angling it downwards slightly. I have the screen in my Elise at dash-top level and have no problems with reflections.

trashbat

6,310 posts

183 months

Monday 21st April 2025
quotequote all
Noted about the convertible but I think your best bet will be one that clips on to an air vent horizontal flap and gives you control over angles etc.

I have one like this, but it's just some generic one off Amazon rather than anything special.

airsafari87

3,305 posts

212 months

Monday 21st April 2025
quotequote all
Have a look at Quad Lock

Hoofy

80,084 posts

312 months

Monday 21st April 2025
quotequote all
I have an ultra cheap vent holder (£1.50?) in each of the cars... or, just to make those in that other thread grind their teeth, deployed in my fleet. biggrin

As a poster above says, just have it pointing downwards a little to avoid reflections.

SteBrown91

3,139 posts

159 months

Monday 21st April 2025
quotequote all
Depending on how much you want to spend look at Brodit mounts - they are good but pricey.

For example if you ever saw a car with a dealer for Bluetooth screen thing popular back in the day it was probably mounted with a brodit kit.

Depends on the car but they normally fit between the main dash structure and the trim somewhere, then you buy the relevant attachment for the phone etc.

Huzzah

Original Poster:

29,018 posts

213 months

Monday 21st April 2025
quotequote all
Mandat said:
I've used something like this in the past, which clamps into the CD slot on your dash

https://www.amazon.co.uk/s?k=cd+slot+mount+car+pho...
That looks pretty good actually, no idea they existed.

JimbobVFR

2,822 posts

174 months

Monday 21st April 2025
quotequote all
Would your sucker mount stick better to the Stereo screen? If you're not using it that much worth a try I'd say.

Tickle

6,480 posts

234 months

Monday 21st April 2025
quotequote all
Have a look and see if https://www.brodit.co.uk/ do something for your car. A few with S1 Elise use them (off the back of your convertible point)

WelshPetrolhead

1,021 posts

165 months

Monday 21st April 2025
quotequote all
I use a quadlock with the mag mount suckered to the windscreen screen as low as possible next to the a-post on both my cars. Doesn't interfere with driving view, but good for a quick glance with nav. Not cheap with a corresponding case, but love that it's minimal fuss, phone just grabs on instantly.

MK3 Dan

382 posts

175 months

Monday 21st April 2025
quotequote all
As others have said, Quadlock is my go too!

Use a windscreen one in car, vent mount in my van, one on my motorbike and push bike etc. Not a cheap set up but I have had no problems - I like the Mag stuff for in the car but then the same case can be used with the locking type on the likes of a bike.

https://www.quadlockcase.co.uk/collections/shop-ca...


Alickadoo

3,439 posts

53 months

Monday 21st April 2025
quotequote all
Huzzah said:
It's a convertible so mounting it higher results in reflections.


I'm wary of damaging the vents.



Edited by Huzzah on Monday 21st April 18:05
I've got one of these by Blukar

https://www.amazon.co.uk/Phone-Holder-Blukar-Cradl...

which fits into the vents and you can adjust the grip. I thit it works.

119

20,072 posts

66 months

Monday 21st April 2025
quotequote all
We had Brodit back in the day.

Pricey but bloody brilliant.

Smint

3,640 posts

65 months

Monday 21st April 2025
quotequote all
Belkin holders are very good too, various designs.

Had a screw tighten adjustable type that fits in cup holders, ideal for trucks, other use truck when i'm off shift so was removed and refitted 4 days every week it lasted some 5 years of rough use before the screw thread finally wore out, the holder itself still as good as new, bought another identical.

mikef

6,158 posts

281 months

Monday 21st April 2025
quotequote all
If you have MagSafe (recent iPhones), then Maus MagSafe vent mounts are good and won’t damage the vents in my experience (I use one in a Porsche) https://uk.mous.co/products/magsafe-compatible-car.... They sell versions with and without charging cable

drmike37

626 posts

86 months

Monday 21st April 2025
quotequote all
I have a miracase 2 vent mounted holder and am very happy with it for £13. Hasn’t damaged the vents and you can tighten it up so it doesn’t wobble.
I bought it just to try it as I was thinking about one of those carplay screen jobbies. I don’t feel like I need the carplay now as i can see everything on my phone.