Tick over revs

[M3144]

Does anyone know what the "tick over" revs are
for an M400.

Just had new inlet maniflod fitted, also MAP sensor
but every time I stop (ie traffic lights etc) it just cuts
out & stalls.

Many thanks

[RobP]

Should be around 800-900 rpm

[YellowShed]

Did they fit a new throttle body at the same time?

Did they re-connect the pipes correctly? Check to see if they pushed the 90deg elbow piece on too hard under the throttle - if they block that, it can lead to problems...

YellowShed

[ajg31]

I had what yellowshed described, caused no end of issues.

[Biggriff]

After checking everything is as Trevor describes think it should be 850rpm (with a/c on)