Managed to tweak a bit more power
Discussion
Just got back from having the TVR Racer tweaked, esp now I have a new camshaft.
Good new it was not far off and running in the safe zone, apart from a few high and low spots.
Bad news They could not get the emerald software to run on there laptop, good job I brought mine, also they was not that up on using the emerald software (they did knock off an hours time though due to there problems)
End result up about 10% across the range, was running 175 BHP at the wheel (at 5300 RPM) before and after 190 BHP at the wheel, so about 230 at the fly, which is about as much as your going to get at of a 4.0 running standard heads.
Also should be a bit more responsive as they spent about 2 hours just sorting the 2k to 4k RPM range. so its got a much better curve.
Not got a scanner at home but will get them to email me a jpg of the before and after power runs.
other good news, the emerald temp sensors are over reading so the car is not running as hot as I thought, will have to calibrate them manually.
Good new it was not far off and running in the safe zone, apart from a few high and low spots.
Bad news They could not get the emerald software to run on there laptop, good job I brought mine, also they was not that up on using the emerald software (they did knock off an hours time though due to there problems)
End result up about 10% across the range, was running 175 BHP at the wheel (at 5300 RPM) before and after 190 BHP at the wheel, so about 230 at the fly, which is about as much as your going to get at of a 4.0 running standard heads.
Also should be a bit more responsive as they spent about 2 hours just sorting the 2k to 4k RPM range. so its got a much better curve.
Not got a scanner at home but will get them to email me a jpg of the before and after power runs.
other good news, the emerald temp sensors are over reading so the car is not running as hot as I thought, will have to calibrate them manually.
Forums | General Motorsport | Top of Page | What's New | My Stuff