diagnostic l mean

[gazza1234]

diagnostic L came up on my dash any help? to what that means?

[whitey]

Yep.

Code L = "look in your handbook". Mind you the early handbooks did not have them!



Here you go....

Tuscan Dashboard Diagnosic codes
A - Speedo not activating zero switch/switch failed/open circuit
B - Speedo not releasing zero switch/switch failed/short to earth
C - Water not activating zero switch/switch failed/open circuit
D - Water not releasing zero switch/switch failed/short to earth
E - Fuel not activating zero switch/switch failed/open circuit
F - Fuel not releasing zero switch/switch failed/short to earth
G - Water temperature sensor input open circuit
H - Air temperature sensor input open circui
I - Oil temperature sensor input open circuit
J - Oil presure sensor input open circuit
K - Fuel level sensor input open circuit
L - Erratic road speed signal input
M
N
O - No communication between analogue and control up

So L is your rear speedo sensor needing adjusted or replaced, but also common for it to come on every now and then when starting the car after it has not been driven for a bit and might come right.

cheers
Whitey

[gillyrx]

Dont panic gazza most tuscans display this code now and then, just a bit of TVR interaction

[R TOY]

Mine often puts a code up, think its trying to spell something out to me. Is there a code W?

[itsadeal]

whitey said:

Tuscan Dashboard Diagnosic codes A - Speedo not activating zero switch/switch failed/open circuit B - Speedo not releasing zero switch/switch failed/short to earth C - Water not activating zero switch/switch failed/open circuit D - Water not releasing zero switch/switch failed/short to earth E - Fuel not activating zero switch/switch failed/open circuit F - Fuel not releasing zero switch/switch failed/short to earth G - Water temperature sensor input open circuit H - Air temperature sensor input open circui I - Oil temperature sensor input open circuit J - Oil presure sensor input open circuit K - Fuel level sensor input open circuit L - Erratic road speed signal input M N O - No communication between analogue and control up

I keep seeing this code chart on here, posted by Whitney and J.Baker thankyou for this,,,,,,,, However what the F**K is M & N about. Are people not sure on these two or are they blank for a laugh?

Paul

[whitey]

Whitney says: "f**ked if I know". I just cut n pasted from Justins post but after checking they dont exist. well not in my manual anyway.

[itsadeal]

whitey said:

Whitney says: "f**ked if I know". I just cut n pasted from Justins post but after checking they dont exist. well not in my manual anyway.

Cheers Whitney

Paul