Can't get her started
Can't get her started
Author
Discussion

optimal noise

Original Poster:

544 posts

248 months

Saturday 15th December 2007
quotequote all
Batterys been dead for about three weeks bought some decent leads but the car won't start tried jumping it off a large van but nothing.

All I'm getting is the car electrics working fine but no turn over sounds like it could be the starter and I know the weather dont help.

When the battery completely dies is there a procedure with the alarm to maybe fully disarm again?

Cheers guys


Whitey

2,508 posts

313 months

Sunday 16th December 2007
quotequote all
what actually happens when you turn the key? Is the fuel pump priming? (the buzzing you can hear when you turn off the imobilisor) Do you get a click from the starter motor? If not it might be an imobilisor problem, try Carl Baker www.tvruk.tv

If you are just getting a click from the starter and the fuel pump is priming, it might be a bad starter motor or not enough current when jumping the car. Remember to hold the doner car at about 3000rpm for about 3 minutes and keep at that rpm before you turn the key on the Tuscan.

Or check the ignition fuse, it might have blown.

Good luck
Whitey

optimal noise

Original Poster:

544 posts

248 months

Sunday 16th December 2007
quotequote all
Cheers for the reply whitey

Dont remember hearing the fuel pump prime so your right it could be the immobiliser although when turning the key and disarming all the electrics come to life so possibly not the fuse.

I'll have another check to make sure and go over the fuses if no luck I'll give Carl a call tomorrow.

Thanks

ec1 eex

400 posts

271 months

Sunday 16th December 2007
quotequote all
Make sure the red light to the left of the pod goes out. If not (like on mine after the battery goes flat) you'll need to disconnect the battery & then re-connect in order to reset the immobiliser.

optimal noise

Original Poster:

544 posts

248 months

Sunday 16th December 2007
quotequote all
Hi Phil

Would I have to disconnect the battery whilst hooked up and on charge (I've got the Anderson connectors) or disconnect the flat battery reconnect then jump start.

ec1 eex

400 posts

271 months

Sunday 16th December 2007
quotequote all
You'd need to disconnect the andersen connector at the same time as disconnecting the battery or the immobiliser unit would still be powered up.

I'd suggest that you then reconnect the andersen (assuming it's plugged in & hooked up) before reconnecting the battery.

optimal noise

Original Poster:

544 posts

248 months

Sunday 16th December 2007
quotequote all
I'm going to give it a go tomorrow evening fingers crossed she'll roar into life.

Thanks mate