windscreen washer not working
windscreen washer not working
Author
Discussion

smithy.e

Original Poster:

18 posts

233 months

Monday 31st March 2008
quotequote all
the stalk operates the wiper but not the washer can anyone please tell me where is the washer motor and how to get to it or suggest what else might cause the problem. Thanks smithy.e

andyoleary

1,713 posts

242 months

Monday 31st March 2008
quotequote all
Smithy,

If you open the service bonnet, you will see the washer bottle at the front, near-side of the car - the filler cap anyway. You need to take the main bonnet off to get at the pump which is fitted to the bottle (I think). If you just have the electrics enabled and pull the stalk, listen out for the pump whirring - if it doesn't then you might have a fuse gone or a problem with the wiring or pump.

HTH

Andy

tuscan_al

4,112 posts

243 months

Monday 31st March 2008
quotequote all
Mine did that too.

YOu can slide the washer bottle out past the headlights its on a bracket in the inner wing. The the motor pump unit pulls off the bottle. Mine I opened up to find the motor was rust and full of water, think overfillign the bottle when I first got the car (thought was bigger than 1 ltr) had got into the motor housing. Anyway dried it out and cleaned it up, all worked again after. Just make sure you get the flat part of the motor output shaft on the right part of the impellor. Mine was not first time and the water took ages to come through.

HTH

Whitey

2,508 posts

313 months

Monday 31st March 2008
quotequote all
also the jets block up with lack of use.

smithy.e

Original Poster:

18 posts

233 months

Monday 31st March 2008
quotequote all
cheers,
I have already had the main bonnet off and checked the fuses. al when you say past the headlights do you mean out by the front wheel under the wheel arch or does the main bonet or the service bonnet need to come off.

thanks smithy.e

NCE 61

2,457 posts

310 months

Monday 31st March 2008
quotequote all
The washer pipe can also come off under the scuttle panel, a small tie wrap keeps them in place.

J J

203 posts

222 months

Tuesday 1st April 2008
quotequote all
Just check that pipe hasent got to close to exhaust heat and shrunk the pipe or melted it. !

jilapau

306 posts

236 months

Tuesday 1st April 2008
quotequote all
My washer tubes keep melting due to the heat coming up from under the bonnet. I have had it fixed 4 times and it has happend again!

smithy.e

Original Poster:

18 posts

233 months

Tuesday 1st April 2008
quotequote all

I did look at the pipes and connections, I can't hear the washer motor running. 'tuscan al' suggestion seems the most likely I hoping he will get back to me in more detail about removing the motor.

cheers smithy.e

Dave PORTER

156 posts

299 months

Wednesday 2nd April 2008
quotequote all
JJ the zoo keeper !. My animals are bigger than yours..Cure your probs tommorow......

J J

203 posts

222 months

Friday 4th April 2008
quotequote all
So much for big animals. Hope you enjoyed the tart I got for you, get your own next time. Bonnet pimple not burst yet, regards Jonny Morris

smithy.e

Original Poster:

18 posts

233 months

Thursday 10th April 2008
quotequote all
Problem sorted was the rusty washer motor cleaned it put back fine.

smithy.e

tuscan_al

4,112 posts

243 months

Friday 11th April 2008
quotequote all
Good glad you got it fixed smile