Tuscan front lights.

[TVRleigh_BBWR]

Hi Could somone tell me if the Tuscan's use 90mm Hella lights.

Also is the lower one the headlight and upper one the full beam light or are they the other way round.

Thanks
Leigh

[BigJL]

Hey,

Not sure what bulbs they are but the dipped beam lights are at the top and the full beam are at the bottom.

[TVRleigh_BBWR]

BigJL said:

Hey,

Not sure what bulbs they are but the dipped beam lights are at the top and the full beam are at the bottom.

Thank you.

also does anyone know if the dipped beam, can be converted so the beam is ok for europe / USA.

Thanks
Leigh.

[Funky Jo]

The technical control claims that my head-lights are at least 3/4-inch too high and thus are blinding the opposite traffic... car failed homologation purely for this little issue :-(

How can I adjust the hight / bring it 1.5cm down ? Are there adjustment screws, or would it be the whole lamp's body to move ???

Thanks for advice guys.

Funky Jo

[Chequred Demon]

If you have adjustable shock absorbers with adjustable spring perches you may be able to get 3/4" lower ride height by lowering the spring perches just for the test.

Presuming you have 18" spiders, another way would be to get some 16" early Tuscan wheels and put low profile rubber on them, the rolling radius would be 1" less with the same profile tyres on - again just for the test.

[TVRleigh_BBWR]

Funky Jo said:

The technical control claims that my head-lights are at least 3/4-inch too high and thus are blinding the opposite traffic... car failed homologation purely for this little issue :-(

How can I adjust the hight / bring it 1.5cm down ? Are there adjustment screws, or would it be the whole lamp's body to move ???

Thanks for advice guys.

Funky Jo

they do have 3 adjusters and can be adjusted from the front or rear, not sure how easy the access is to thse on the tuscan.

[glow worm]

Funky Jo said:

The technical control claims that my head-lights are at least 3/4-inch too high and thus are blinding the opposite traffic... car failed homologation purely for this little issue :-(

How can I adjust the hight / bring it 1.5cm down ? Are there adjustment screws, or would it be the whole lamp's body to move ???

Thanks for advice guys.

Funky Jo

Don't know if it's a MK2, but take off main bonnet and remove the panel behind lights, there are adjustable screws on each light unit.