Clutch Failure Advice Fitting

[Steve--P]

Is there anything I need to know about fitting a new clutch such as Special tools or any processes that need to be carried out in specific order or is it the same as a Chimaera which is pretty straight forward
Thanks in advance

Steve

[duntus]

Steve--P said:

Is there anything I need to know about fitting a new clutch such as Special tools or any processes that need to be carried out in specific order or is it the same as a Chimaera which is pretty straight forward
Thanks in advance

Steve

If you need someone to fit it i can get you the person that done mine,tvrdave.£150.00 approx essex.colin 07711919568.

Edited by duntus on Sunday 7th June 22:40

[lee02]

just had mine done by local clutch specialist. Didnt have time to take to specialist as going to lemans on thursday. The clutch plate is reasonably straight forward BE CAREFULL the springs wear to outside of the flywheel if Too bad turn plate by 2 bolts so springs are on virgin flywheel. Otherwise you will have no travel. Also slave cylinder is a bit of a bh but O rings must be changed they fail! also any scoring replace it, Make sure holes line up and are at top makes it easier to bleed.Be very careful with O rings do not nick them. Other than that a ramp and basic mechanical knowledge will get you through.

[Steve--P]

Thanks fella's, done many a clutch in my day so hopefully won't be a problem then, new clutch should be here tomoz
Thanks again
Steve

[Whitey]

A Cerb owner I think MadMark? did a how to write up on replacing the clutch, maybe ask on the Cerb forum, actually here it is on clever Trevor:
http://www.clever-trevor.net/manuals/

[Steve--P]

Whitey said:

A Cerb owner I think MadMark? did a how to write up on replacing the clutch, maybe ask on the Cerb forum, actually here it is on clever Trevor:
http://www.clever-trevor.net/manuals/
Nice one Whitey
Some real useful tips in that link you posted
will get stuck into that this weekend as car needs to be ready for Goodwood FOS
Thanks alot Mate

Best Regards
Steve

[nelly1]

Steve - if you need a hand with the gearbox, etc, don't hesitate to give me a bell.

ATB

Neill