Blowing Fuses when selectin reverse
Discussion
Every time I select reverse, the fuse blows, so the brake lights don't work either. Disconnected the reversing light so that leaves the reversing switch or a break in the wiring. Does anyone have a wiring diagram. About to attempt to get to the reversing switch has anyone any tips.
Thanks in advance.
Thanks in advance.
I had the same problem. I had my garage sort out the bad connection between the pin on the gear stick and the plate . I'm afraid its a real TVR bodge job, apparantly the proper connection could not be used because of the heat caused by the proximity to the exhaust. You can get at it from underneath with the car on a ramp ,but its awkward, otherwise its take the centre console off.
I also had this problem and it was the reverse light switch that is mounted on the gearbox next to the gear stick.
The plastic insulator between the ball bearing and switch internals had worn a tiny hole in it which shorted it out every time reverse was selected. Its an old ford part but they no longer stock them, you can buy them from the normal TVR suppliers. As has already has been said its a center console out job to fit it.
Its fairly simple job to fit although the lack of space doesn't help.
Rich
The plastic insulator between the ball bearing and switch internals had worn a tiny hole in it which shorted it out every time reverse was selected. Its an old ford part but they no longer stock them, you can buy them from the normal TVR suppliers. As has already has been said its a center console out job to fit it.
Its fairly simple job to fit although the lack of space doesn't help.
Rich
Forums | Tuscan | Top of Page | What's New | My Stuff




.. Tell them it never had a light 