Car won't start
Discussion
gazzab said:
have always been told that you shouldnt bump start a cerb. I assume it is cats and clutch that dont like it.
Gaz, it was Austec that bump started my car when the starter went tits up on their forecourt (and it needed to be away from there for the warranty claim
). Dont have any cats and cant see why it would be a problem for the clutch?FUBAR said:
c6erb said:
The sound is more of a high pitched whine than a buzz.
Starter motor 
Strange that you mention a high pitched whine. Sometimes, when i start my Cerb, i get this high pitched whine coming from the rear somewhere - sounds like an electrical whine rather than mechanical, and it goes after a few seconds, and when it does appear it is after the car has started, not before or during. Strange
gbbird said:
FUBAR said:
c6erb said:
The sound is more of a high pitched whine than a buzz.
Starter motor 
Strange that you mention a high pitched whine. Sometimes, when i start my Cerb, i get this high pitched whine coming from the rear somewhere - sounds like an electrical whine rather than mechanical, and it goes after a few seconds, and when it does appear it is after the car has started, not before or during. Strange
It's not the fuel pump priming is it?
Do you have a test meter you can put across the battery to check the voltage? I'd say check the voltage if it's low, get a jump start from someone and check the voltage again while the car is running. It should >13v, might be > 14v. The alternator warning light on the dash (orange one iirc) should go out after the car starts. If it doesn't your battery has been flattened because it wasn't being charged by the alternator. A common cause is the infamous big fuse (cheap to fix) a less common and much more expensive cause is a dead alternator. The AA will be able to check this is you're not happy too/don't have any tools available.
Steve.
Steve.
Edited by Steve_T on Monday 24th July 16:02
Forums | Cerbera | Top of Page | What's New | My Stuff




) and some graunching noises to warn me. Then when they finally went was just the whizzy/whiney noise when something or other sheared