Torque Settings lb.ft

Please Update Torque Settings by copying the following line, pasting at the bottom of the list, and substituting the correct values...

||Description||nn||.

Please add other relevant and useful information at the bottom.

====================

Description	lb.ft
Anti Roll bar Rear	?
Anti Roll bar Front	?
Bellhousing to Gearbox	50
Bellhousing to engine	50
Brakes: Caliper mount to hub carrier	40-45
Brakes: Caliper to Caliper mount	40-45
Brakes: Caliper to carrier	40-45
Brakes: line banjo bolt	9-10 + 90 degrees
Brakes: Caliper Halves M8 (12.9 grade) bolts	29
Brakes: Caliper Halves M10 (12.9 grade) bolts	57
Brakes: Bleed nipple	12
Brakes: Pad retaining bolt	10
Cam/Rocker Covers	15
Cam bearing caps	17
Cam sprocket to camshaft	20
Clutch cover to flywheel	25
CV Joints	28-32 + loctite
Diff front bracket to chassis	95
Drag link to chassis	40-45
Drag Link to suspension arm	45-50
Flywheel to crank spigot	60
Front hub centre bolt	70-75
Hub to hub carrier	45-50 + loctite
Lambda sensors	finger tight + 180 degrees
Lower ball joint taper nut	60-70
Lower ball joint to suspension	20-25
Rear Hub - Driveshaft/Hub 41mm nut (*1)	220
Shock Absorbers	45-50
Slave cylinder to bellhousing	15
Starter Motor to Engine	18
Steering arm to hub carrier	45-50
Track rod end taper nut	35-40
Upper ball joint plate to hub carrier	20-25
Upper ball joint to plate	50-55
Wheel nut	55-60
Wishbones Lower	55
Wishbones Upper	40-45
Propshaft to Diff flange bolts	45
Gearbox Fill & Drain plugs	20

(*1) Thread tightening direction is in the direction of Wheel Rotation

Tracking and Camber Settings

Camber Degrees - Front and Rear : 0.5 - 1.25 negative

Caster Degrees - Front : 3.5 - 4.5 positive

Toe In (Minutes) - Front and Rear : 10 - 20

Ride height (Meausured from Outrigger corners to ground)

Front 125mm
Rear 130mm

Coolant Hose ID - Hoses to Thermostat (3) - 35mm