Alarm Problems.
Discussion
Here you are mate, straight from the manual...
To disable the interior ultrasonic sensors, press and hold the button on the radio key for approximately 4 seconds. This is indidicated by a series of fast flashes of the hazard lights. The sensors will be automatically introduced when the system is next operated.
There are also some system diagnostics...
The LED at the top of the rear screen will flash in one of the following sequences to indiacate which circuit triggered the alarm..
Ultrasonics - 1 flash every 6 seconds
Doors - 2 flashes every 6 seconds
Boot or bonnet - 4 flashes blah blah
Panic facility - 16 flashes blah blah
This may tell you whats happening
And no there isn't a bonnet switch.
Paul
To disable the interior ultrasonic sensors, press and hold the button on the radio key for approximately 4 seconds. This is indidicated by a series of fast flashes of the hazard lights. The sensors will be automatically introduced when the system is next operated.
There are also some system diagnostics...
The LED at the top of the rear screen will flash in one of the following sequences to indiacate which circuit triggered the alarm..
Ultrasonics - 1 flash every 6 seconds
Doors - 2 flashes every 6 seconds
Boot or bonnet - 4 flashes blah blah
Panic facility - 16 flashes blah blah
This may tell you whats happening
And no there isn't a bonnet switch.
Paul
Had a similar prob with mine.
Check your boot light switch is actually turning the light off when the boot is shut. The switch is adjustable and located either to the left or right of the boot hinge. Ps I think the light comes from a Rover. If it still plays up pull the wire off because when mine got wet it shorted out the contacts within the switch. Got a new switch, took it apart and filled it with grease. Perfect.
Check your boot light switch is actually turning the light off when the boot is shut. The switch is adjustable and located either to the left or right of the boot hinge. Ps I think the light comes from a Rover. If it still plays up pull the wire off because when mine got wet it shorted out the contacts within the switch. Got a new switch, took it apart and filled it with grease. Perfect.
Message Board | Cerbera | Top of Page | What's New | My Stuff




