Pulling of passenger side fender

[Raggyman]

Hey kids, how do you go about pulling off the passenger side fender? Got to replace the aerial mast, and don't want to get into it if it is going to be a big job.

[motomk]

I have recently done one of these although I replaced the whole aerial and motor. The fender doesn't need removing. I might have to make sure we are talking about the same thing here.
You need to remove the plastic wheel arch cover inside the wheelwell. I also had to remove some of the interior trim around the glovebox to get at the connectors. I also removed the front wheel I think to make it easier to get in there to have a look what I was doing. I removed the whole mast and mount and tried to work out how to remove the mast on a table. I couldn't work it out as there were some connections that were obviously different to what was ment to be there. So I caved in and drove back up to Holden and bought the whole mast and motor assembly. Aerpro make a clone of it too, if you have them over there.

motomk

Edited by motomk on Tuesday 10th July 13:34

Edited by motomk on Tuesday 10th July 13:40

[Raggyman]

Ah ok, cool, might give it a go, and try and take some photos along the way...
Yeah, i just got the arial and mast from home, so hopefully it is going to be an easy operation.

Edited too say thanks heaps mate, greatly appreciated..

Edited by Raggyman on Tuesday 10th July 13:48

[motomk]

Do you have an email address? I can drop you some instructions on how to do it.
edited....is it an electric one or a manual operated one?

motomk

Edited by motomk on Tuesday 10th July 13:59

[Raggyman]

YHM... it is an electric one..

[Raggyman]

Thanks heaps mate, greatly appreciated.