Wheel balancing issue and solution
Wheel balancing issue and solution
Author
Discussion

68Jaybee

Original Poster:

42 posts

11 months

Sunday 1st November
quotequote all
I picked up a nail a couple of months ago in my DB9, naturally close to sidewall of the front tyre necessitating a replacement.

Subsequently, I notice vibrations in the steering at around 70mph, so I took the car back to the tyre shop and asked them to rebalance it again. They claimed that the wheel was already balanced, but made a minor move in the weights to see if this would correct it.

The issue persisted though evident at a slightly different speed , oh well think I’ll get an Aston specialist to sort it out when it gets serviced next month.

A couple of days ago, I noticed that I’d gotten a nail in the other front tyre, which I presume was well jammed in as the pressure remained sound. I got this fixed (thankfully not a new try this time). The balancing issue now perfect and the car drives fine. On reflection, I must have picked up both nails at the same time, thank you very much Mr Builder 👷‍♂️ what a thoughtful fellow you are where ever you are.

Amazing to think that a nail weighing a gram or two is enough to unbalance the wheels. Me thinks that Astons have a princes and the pea type complex.

Greathey

249 posts

87 months

Monday 2nd November
quotequote all
Good to know that. Here we have technicians who balance wheels while still on the car. They usually do better than normal machine balancing

68Jaybee

Original Poster:

42 posts

11 months

Monday 2nd November
quotequote all
Where is that? I always worry about the brittle CCBs when the wheels come off

8Tech

2,221 posts

229 months

Thursday 12th November
quotequote all
Greathey said:
Good to know that. Here we have technicians who balance wheels while still on the car. They usually do better than normal machine balancing
I would like to know that too. I used to balance wheels on the vehicle when I worked at a Ford Main dealer and have been looking for a used machine but just cannot find any. Its the best way because you are balancing wheel, tyre, disc and hub all together. Even valves and locking wheel nuts are taken into tne equation.

I believe this is especially important on CCM discs and there is a TSB on the procedure to balance the discs separately. I have fully floating discs and 8 pots on the front and 6 pots on the rear and would love to balance them on the car.



LTP

3,159 posts

143 months

Thursday 12th November
quotequote all
I was under the impression that on-car balancing can be bad for auto gearboxes and some LSDs.