classic shape ideas (subaru)

[classicconundrum]

hi ,everyone im new to piston heads and am startin this discussion mostly as a trial on how the site works but also for intrest in others opion .

limited slip diff
i brought this of someone ,it was off a uk impeza turbo 2000 v.2. he brought the diff new and he done little miles before he stufed the car in a tree.he then removed the diff from the car along with other parts. since ive had it i ve striped it down cleaned it and have removed one of the bearings so i could could take it round to find a new set for it,but i have been unsuccessfull in finding.
does anyone no any were good to get bearings for this type of thing/ a supplier ?

also are they a good mod ?

Edited by classicconundrum on Wednesday 21st October 16:16

Edited by classicconundrum on Wednesday 21st October 16:19

Edited by classicconundrum on Wednesday 21st October 16:24

Edited by classicconundrum on Wednesday 21st October 16:26

Edited by classicconundrum on Wednesday 21st October 16:27

[JollyGrnMonster]

if you take to a bearing specialist they will be able to measure and sort probablty off the shelf

there is usually a bearing specialist in most bit industrial estates..

but to be honest never had to change bearings in probably half a dozen subaru diffs I have used.. actually must be at least 10 diff if I include all 5 subarus I have owned.. lol

Simon

[classicconundrum]

thanks m8
i was just changing the bearingd out of caution cus being lieing arouicend for awhile but thsnks for the advice
cheers again