Swirl flaps and Walnut blasting N47
Swirl flaps and Walnut blasting N47
Author
Discussion

Rossco196x

Original Poster:

154 posts

105 months

Friday 13th November
quotequote all
Hi my N47 engine in my E92 has always been rather sluggish despite being the bi Turbo 123D variant with a remap and hence i decided to remove the inlet manifold after the smoke tester identified a rather large leak around the swirl flap shaft where the actuator fits at the front of the engine.

Question 1: Its done 115k miles and the manifold is rather dirty and also the inlet tracks hence is there any where offering mobile walnut blasting local to Portsmouth or should i buy the gear and do it myself as i have a compressor.

Question 2: I have the swirl flap delete kit but would it be better to buy a new manifold and retain the swirl flaps as i fear the gain in top end power only is not worth the loss in bottom end power and a lower mpg associated with removing the flaps.

Thanks in advance

RossCo


Jakg

4,070 posts

199 months

Friday 13th November
quotequote all
Rossco196x said:
Hi my N47 engine in my E92 has always been rather sluggish despite being the bi Turbo 123D variant
I didn't think that engine ever ended up in an E9x scratchchin

Rossco196x

Original Poster:

154 posts

105 months

Friday 13th November
quotequote all
Mine is a D3 Alpina Bi Turbo and it is fitted with an N47 4 cylinder that is basically the same as a 123d engine

danb79

13,960 posts

103 months

Friday 13th November
quotequote all
Rossco196x said:
Hi my N47 engine in my E92 has always been rather sluggish despite being the bi Turbo 123D variant with a remap and hence i decided to remove the inlet manifold after the smoke tester identified a rather large leak around the swirl flap shaft where the actuator fits at the front of the engine.

Question 1: Its done 115k miles and the manifold is rather dirty and also the inlet tracks hence is there any where offering mobile walnut blasting local to Portsmouth or should i buy the gear and do it myself as i have a compressor.

Question 2: I have the swirl flap delete kit but would it be better to buy a new manifold and retain the swirl flaps as i fear the gain in top end power only is not worth the loss in bottom end power and a lower mpg associated with removing the flaps.

Thanks in advance

RossCo
IMO just buy a new manifold; keep the flaps in situ as they help with the torque etc - they've done this this far, why try and fix what's not broken?

Rossco196x

Original Poster:

154 posts

105 months

Saturday 14th November
quotequote all
Thanks for the advice Dan.

I've decided to buy a new manifold and that should arrive on Weds c/w swirl flaps and gaskets. It will be interesting to weigh and compare the new one to the old to see how much gunk it contains and for the cost it seems far less hassle than using 5 tins of Mr Muscle and making a mess on the drive.

I bought the car to replace my 231k Golf VW GT Sport as it was meant to be fast and good on fuel hence there seems little point in removing the swirl flaps if it results in less MPG and torque.

I've also order some walnut grit and some additional tools clean the ports myself.

Thanks

RossCo

Rossco196x

Original Poster:

154 posts

105 months

Saturday 14th November
quotequote all
Thanks Dan i'm refitiing a new standard manifold and cleaning the inlets myself