Cleaning Brake Discs
Discussion
So the discs on my track bike are showing little black marks around the surface of the pad contact area which coincided with the beginnings or brake shudder under hard braking last time out at Calabogie. So clearly there's pad material being deposited on the rotor surface but the question is what's the best way to remove the marks?? Any tips or tricks or simply sand paper and elbow grease?? Would sand blasting work??? Asking for a friend obviously Cheers
If the pad debris is collecting in the holes of a cross drilled disc, I take a drill and use a drill bit slightly smaller than the hole to remove it all..
Takes a couple of minutes when you get used to it.. helps if the wheel is off the ground and you can drill n spin, drill n spin...
Takes a couple of minutes when you get used to it.. helps if the wheel is off the ground and you can drill n spin, drill n spin...
At around 60,000 miles I started getting judder when braking from highish speeds - 2005 Audi A8,original discs. I was told they had warped. Clearly nonsense. I think they somehow develop areas of different coefficients of friction. I took them off, hammered off the rust and ground down the peripheral lipping, then honed the shiny work surface with a carborundum wheel. Problem solved, still OK at 80,000 miles.
Gassing Station | Biker Banter | Top of Page | What's New | My Stuff


