Best place for new veneer
Best place for new veneer
Author
Discussion

Norv

Original Poster:

33 posts

176 months

Monday 19th March 2012
quotequote all
Where's the best place to get new veneer from?

Hedgehopper

1,542 posts

275 months

Monday 19th March 2012
quotequote all
http://www.veneeruk.com/
http://www.woodveneeruk.co.uk/categories.php?cat=4...
http://www.originalmarquetry.co.uk/category_Wood_V...

Haven't tried any of these yet but re-veneering the dash is on the 'to do' list. There are several articles on RV8R and Pistonheads about this subject.

swanny71

3,603 posts

240 months

Monday 19th March 2012
quotequote all
I used these guys to buy my veneer - very helpful

http://www.veneeruk.com/

Hope to get it all glued up this weekend

Jonny cobra

615 posts

243 months

Monday 19th March 2012
quotequote all
got mine from ebay they are from nuneton . got 2 sheets only used 1 american walnut burr real nice too.
am polishing my dash at the mo . well pleased cost was £ 40 including post ..

JC..

pmanson

13,388 posts

284 months

Monday 19th March 2012
quotequote all
swanny71 said:
I used these guys to buy my veneer - very helpful

http://www.veneeruk.com/

Hope to get it all glued up this weekend
Just around the corner from me... might see if I can swing by and take a look

Norv

Original Poster:

33 posts

176 months

Monday 19th March 2012
quotequote all
So ya don't get it ready cut with the holes for the dials? It's a sheet that ya av t cut ya sen? :-/

EGB

1,774 posts

188 months

Monday 19th March 2012
quotequote all
Jonny cobra said:
got mine from ebay they are from nuneton . got 2 sheets only used 1 american walnut burr real nice too.
am polishing my dash at the mo . well pleased cost was £ 40 including post ..

JC..
Would love to see a picture. Any 8inch X half inch offcuts left over. For the bit under my radio. Will pay hansomly.

Jonny cobra

615 posts

243 months

Tuesday 20th March 2012
quotequote all
Hi i have a sheet that is 36inch long and 8.5 inch wide so should be just big enough LOL;; I have to do my radio panel yet so plenty m8 ..

I will get some pickys up later ,,,

John.