Discussion
I'd like to get a bit more angle on the base part of the driver's seat. Whilst I could put spacers under the front, what I'd really prefer is to lower the back half by about 0.5 inch, which would give me back some of the driving position of my old 4.0 which was so comfy. Unfortunately, this end is bolted straight through the carpet already, with nothing to remove. Underneath, there's a thick wire/cable running centrally from front to back, with about 20 thinner horizontal wires that thread through it. The only fix I can think of is to cut some of the wires that support that end. If I snip a few, do you reckon it will do the job or will the whole thing unravel and fall apart?
quote:
I'd like to get a bit more angle on the base part of the driver's seat. Whilst I could put spacers under the front, what I'd really prefer is to lower the back half by about 0.5 inch, which would give me back some of the driving position of my old 4.0 which was so comfy. Unfortunately, this end is bolted straight through the carpet already, with nothing to remove. Underneath, there's a thick wire/cable running centrally from front to back, with about 20 thinner horizontal wires that thread through it. The only fix I can think of is to cut some of the wires that support that end. If I snip a few, do you reckon it will do the job or will the whole thing unravel and fall apart?
Have you still got the standard runners under there? They add about an inch to the height?
Forums | Chimaera | Top of Page | What's New | My Stuff



