Emerald ECU connector identification
Discussion
Over the winter I intend to make a custom loom for the car and am currently writing a list of part's I will need to undertake the job.
I have gone through both looms and have the descriptions and part numbers for each component other than two which are used in the Emerald ECU.
The first connector is the 7 pin chassis interface connector which is a sealed round connector with three male bullets and 4 female bullet connectors in the end I require.
The second connect looks very similar to a 4 pin Econoseal female connector however it is only a 2way connector however is significantly taller than the 2way Econoseal. This is used for the water thermostat.
Any help is appreciated.
I have gone through both looms and have the descriptions and part numbers for each component other than two which are used in the Emerald ECU.
The first connector is the 7 pin chassis interface connector which is a sealed round connector with three male bullets and 4 female bullet connectors in the end I require.
The second connect looks very similar to a 4 pin Econoseal female connector however it is only a 2way connector however is significantly taller than the 2way Econoseal. This is used for the water thermostat.
Any help is appreciated.
My 7 is Zetec/Emerald and all my connectors came from them. Have you checked the 'shop' on their website www.emeraldm3d.com ?
Gassing Station | Caterham | Top of Page | What's New | My Stuff