Roof Stays
Roof Stays
Author
Discussion

Sandgrounder

Original Poster:

564 posts

170 months

Tuesday 26th June 2012
quotequote all
Hi, I am told the Chimaera alloy roof stays will fit my TVR S3. Anybody know where I can get a couple from?

Thanks

phillpot

17,489 posts

209 months

Tuesday 26th June 2012
quotequote all

Keep an eye on the classifieds and Ebay, usually go for £100+ a pair !

Gerald-TVR

4,896 posts

223 months

Tuesday 26th June 2012
quotequote all
Sandgrounder said:
Hi, I am told the Chimaera alloy roof stays will fit my TVR S3. Anybody know where I can get a couple from?

Thanks
Yep but geometry is slightly different and you have to re-drill one mounting hole each side

HvdWeerden

1,739 posts

226 months

Tuesday 26th June 2012
quotequote all
I have a set to sell, PM me for details

Han

Sandgrounder

Original Poster:

564 posts

170 months

Tuesday 26th June 2012
quotequote all
Hello Gerald-Tvr (Norman isn't it?), Have you replaced them on your S?

I was hoping it was a straight swap. Do you have any details about the re-drilling? ie. is it obvious where to drill, or am I likely to install them incorrectly?

Thanks

TVR-Stu

836 posts

225 months

Tuesday 26th June 2012
quotequote all
Here are some on e-bay at the moment linky

Nothing to do with me, but the price is about normal.

Fitting is pretty straight forward, as others have said just a case of drilling new holes fractionally below your current holes in the rear/lower panel. If you fit them in place on the hoop section and then offer up to the lower panel with the hood up you'll see where you need to drill. Just make sure that you tension the hoop so you get a nice tight fit.

v8s4me

7,270 posts

245 months

Tuesday 26th June 2012
quotequote all
Try and do it on a warm day, it helps if the hood & window are quite flexible. I was lucky, mine fitted into the exisiting holes so give it a try before drilling new ones. You might get away with just easing out the bottom of the existing holes.

Gerald-TVR

4,896 posts

223 months

Tuesday 26th June 2012
quotequote all
Sandgrounder said:
Hello Gerald-Tvr (Norman isn't it?), Have you replaced them on your S?

I was hoping it was a straight swap. Do you have any details about the re-drilling? ie. is it obvious where to drill, or am I likely to install them incorrectly?

Thanks
Yep thats me I did replace them on Gerald my S2 now moved on, about 1/2" or less BUT it depends on the car each pair of stays were individually fitted at the factory to give the correct tension to the rear hoos section!! TVRs - each is an individual!!

Longers

4,504 posts

254 months

Tuesday 26th June 2012
quotequote all
HvdWeerden said:
I have a set to sell, PM me for details

Han
I'm seeing Han at the Le Mans Classic over weekend of 7 & 8 July so if anyone wants these I can bring them back to UK and post from home (or arrange for you to collect) which will save you some £s on shipping from Holland wink