BEZ
Author
Discussion

brettster

Original Poster:

146 posts

269 months

Thursday 6th February 2014
quotequote all
Hi all, tried searching for the best way to clean or take paint off the instrument bezels as I have a couple that the paint is coming off and I am not too sure the best way to go about it. confused Just wondered if anyone on here has done anything to improve theirs or any other ideas??
Ta very much for any input.
Brett

S2Mike

3,065 posts

179 months

Thursday 6th February 2014
quotequote all
I am trying to get mine to all match, the Rev counter had encountered some water and rusted. I found wire wool carefully rubbed around the bezel gently removes it and does not seem to mark the glass, but it takes ages. Some have merely polished them up to shiny silver and then lacquered them. I plan to get some matt black spray and hopefully match the whole set.

jned2

218 posts

158 months

Thursday 6th February 2014
quotequote all
I rubbed mine back using wire wool, but be careful with the clock face because on my S3 it's plastic not glass that covers it. I found it OK to do the "inside" surface of the bezel but the "outside" surface I found an all together much more difficult job. I also found it easier to remove the steering wheel. Masking off the dash and the glass (plastic for the clock) took ages, I then used aluminium paint from a rattle can and a couple of coats of lacquer to finish off the job. Not as good a real ally bezels but looks better than rust and flaky paint.

Scoobimax

1,892 posts

230 months

Thursday 6th February 2014
quotequote all
I quite fancy doing this to mine but always shy'd away but was thinking about a small Dremmel type tool might work?

phillpot

17,508 posts

212 months

Thursday 6th February 2014
quotequote all


Mask off the glass before you do anything!!!!


Got to be masked for painting anyway so why risk scratching it?

brettster

Original Poster:

146 posts

269 months

Friday 7th February 2014
quotequote all
Cheers for the ideas, masking and spraying sounds like a good idea but also a bit scarey!! I tend to get a bit messy with spraying, lol. I think I will give the old wire wool a crack and see how that goes.
Thanks once again. clap
Brett

TurboTony

908 posts

200 months

Friday 7th February 2014
quotequote all
Mine were rubbed and scratched on the bezels when I got the car. I sprayed some satin matt black paint into a cap and carefully touched them in with an artists brush. From the drivers seat they look fine.


brettster

Original Poster:

146 posts

269 months

Saturday 8th February 2014
quotequote all
They do look good tony, but you must of had a steady hand mate, I think I would get paint all over the dash!!lol

HvdWeerden

1,739 posts

229 months

Saturday 8th February 2014
quotequote all
TurboTony said:
Mine were rubbed and scratched on the bezels when I got the car. I sprayed some satin matt black paint into a cap and carefully touched them in with an artists brush. From the drivers seat they look fine.
I knew I recognised that signpost, Eurotour 2013 fuelling for a brilliant day in the alps on my birthday :-)

Han


Longers

4,505 posts

257 months

Saturday 8th February 2014
quotequote all
TurboTony said:
Tony, I hope you were NOT doing 10mph while taking a photo of your dials!

glenrobbo

40,450 posts

179 months

Saturday 8th February 2014
quotequote all
Longers said:
Tony, I hope you were NOT doing 10mph while taking a photo of your dials!
Longers,
When you get to our age ( GTS members ) you will realise that time passes so quickly, you are actually doing 10 mph when stationary.
If you start moving, the rate that time passes becomes exponential*. We need our S's just to keep up.

  • Probably explains why we arrive first at the hotel bar at the end of each day.
It's definitely NOT due to intuitive use of satnav technology.

TARDIS: = Time And Relative Decrepitness in an S. wink

Understand one day you will young Longers.