Quick question from an Interloper

[niva441]

Hi

I've just popped into this forum from the Wedge group.

I needed to replace the oil pressure sender on my 280 and all the TVR dealer could supply was a S series sender.

Obviously I'd like the gauge to read correctly, and I'm assuming if the gauges read them same then the same sender will work.

My tasmin reads oil pressure from 0-100 psi, what is the gauge limits for an S?

Thanks for your time.

Todd

[spivvy]

IIRC Gauge reads the same as S, Pressure is normally half way ie 50 PSI on idle




>> Edited by spivvy on Monday 4th April 10:29

[M@H]

2nd from the bottom

[niva441]

Thanks for that guys. It's good that they read the same, but I may need to attend to the oil pressure.

Very impressive speed of response, did you just nip out and photograph the dash.

[TOPTON]

Any excuse to get a good picture posted is good enough. Surely someone has a question about under the wheel arch or behind the headlight!

[Pies]

spivvy said:

IIRC Gauge reads the same as S, Pressure is normally half way ie 50 PSI on idle >> Edited by spivvy on Monday 4th April 10:29

Your volts look a bit low

[spivvy]

must have left lights on in garage ,
scabby radio has also gone now

[KentishS2]

M@H said:

2nd from the bottom

I still think this dash has the best shape and layout