New Pots and Pipes
Discussion
After a busy weekend I've ended up with this:
and moved the coil to the bulkhead:
The swirlpot/expansion combo was made my forum member ShaunS3C and looks terrific compared to the old setup.
The stainless pipes came from ACT and were manufactured without the Otter Switch hole as I have a separate temperature probe. They get their supplier to manufacture in batches so there are a few more without the holes if anyone needs them.
First test drive tonight then off for a long weekend on Thursday - taking plenty of spare water as the new silicone hose will probably seep until they're fully settled.
Final tip, remember to re-fit the air intakes pipes before spending ten minutes trying to figure out why it will fire up then die........
Steve
and moved the coil to the bulkhead:
The swirlpot/expansion combo was made my forum member ShaunS3C and looks terrific compared to the old setup.
The stainless pipes came from ACT and were manufactured without the Otter Switch hole as I have a separate temperature probe. They get their supplier to manufacture in batches so there are a few more without the holes if anyone needs them.
First test drive tonight then off for a long weekend on Thursday - taking plenty of spare water as the new silicone hose will probably seep until they're fully settled.
Final tip, remember to re-fit the air intakes pipes before spending ten minutes trying to figure out why it will fire up then die........
Steve
Gassing Station | S Series | Top of Page | What's New | My Stuff