Dash switches...
Discussion
Have the TVR part numbers if that will help, don't know what premium they'd want for the bits though.
Fan switch - O25M 013A, although I have posted the lucas part no before if you do a search.
Rear Fog switch - O25M 010A
Front lamp Switch - O25M 010A (Driving lights)
Mirror Joystick switch - O25M 186A
Mirror change over switch - S29M 10106
The symbols/legends come seperately
Fan symbol - S29M 10095
Fog symbol - O25M 094A
Driving light symbol - O25M 267A
Two favours if you do do this
,
1. If you find a way of illuminating the switch symbols better than the existing Fibre Optic one let me know
.
2. This one is more of a tip than a favour, the three position fan switch gives two speeds to the fan as well as off
. Apparently if you go up the back when the centre panel is off you can change the wires over on the fan to give higher speeds. The thinking behind this is that the fan is actually a three speed unit and the wires from the switch just use speeds 1 & 2, I've been told that speeds 2 & 3 are the ones to have
.
Harry
Fan switch - O25M 013A, although I have posted the lucas part no before if you do a search.
Rear Fog switch - O25M 010A
Front lamp Switch - O25M 010A (Driving lights)
Mirror Joystick switch - O25M 186A
Mirror change over switch - S29M 10106
The symbols/legends come seperately
Fan symbol - S29M 10095
Fog symbol - O25M 094A
Driving light symbol - O25M 267A
Two favours if you do do this
, 1. If you find a way of illuminating the switch symbols better than the existing Fibre Optic one let me know
. 2. This one is more of a tip than a favour, the three position fan switch gives two speeds to the fan as well as off
. Apparently if you go up the back when the centre panel is off you can change the wires over on the fan to give higher speeds. The thinking behind this is that the fan is actually a three speed unit and the wires from the switch just use speeds 1 & 2, I've been told that speeds 2 & 3 are the ones to have
. Harry
Podie said:
HarryW said:
1. If you find a way of illuminating the switch symbols better than the existing Fibre Optic one let me know.
Replace the bulb in the fibre optic bit, with an LED one...
How'd you'd do that then
, bulb is standard bayonet fitting, is there a LED type that'll fit, without choping the wires
. Harry
Gassing Station | S Series | Top of Page | What's New | My Stuff






