S3 Temperature Gauge markings
S3 Temperature Gauge markings
Author
Discussion

SteveOS3

Original Poster:

503 posts

220 months

Wednesday 30th September 2009
quotequote all
Following a major overheating problem when stuck in traffic on the Severn Bridge I found that the fan motor had bruned out.

I've fitted a temperature adjustable Kenlowe fan and want it to come on at around 90c but I'm not sure where this is on the dial....

Is 90c when the needle is horizontal or is it when it's near the small white mark just below the red?

I'm playing safe and have set the fan to cut in at the horizontal mark at the moment. Any advice would be appreciated.

Steve

orange_dodo

694 posts

218 months

Wednesday 30th September 2009
quotequote all
I have an S2 so not sure the gauges are the same but my fan kicks in when the needle is a few degrees above horizontal, fairly closeto the line. Even in traffic when it's hot the needle never passes the little line, just about touches it before the temperature drops down again.

Sounds like you may want it set a tiny bit hotter but then again no 2 TVRs are the same!

Gerald-TVR

4,896 posts

226 months

Wednesday 30th September 2009
quotequote all
Same as orange dodo

phillpot

17,511 posts

212 months

Wednesday 30th September 2009
quotequote all
Same here, horizontal or slightly above, never yet touched the line which I reckon is max. ie 100 degrees


jimed

1,508 posts

235 months

Wednesday 30th September 2009
quotequote all
My S3C normally sits with the needle horizontal with the fan coming in when it is a little above that; ie same as per above posts.
Jim

orange_dodo

694 posts

218 months

Wednesday 30th September 2009
quotequote all
Took these on the way home today so it's a little more obvious.


This is the temp when the fan came on


and this is the temp when it went off


Sorry for the poor photos, as you can probably see from the reflection I took them with my phone.

Roy C

4,213 posts

313 months

Thursday 1st October 2009
quotequote all
I've always thought that the white line is 90°. It usually runs up to just below the line and the fan drags it back down (same as orange_dodo).

Le TVR

3,097 posts

280 months

Thursday 1st October 2009
quotequote all
Roy C said:
I've always thought that the white line is 90°. It usually runs up to just below the line and the fan drags it back down (same as orange_dodo).
Agreed.

There can be slight variations with lights on or off as well.

Mine gives the white line as 90° with lights on and about 2mm lower with lights off.

Gerald-TVR

4,896 posts

226 months

Thursday 1st October 2009
quotequote all
Like the dashboard Tom, you, me and about 38 other cars had one with that finish

SteveOS3

Original Poster:

503 posts

220 months

Thursday 1st October 2009
quotequote all
Thanks all, I think I'll tweak the fan to come on just below the line - it's getting a bit nippy in the footwell at the moment!

orange_dodo

694 posts

218 months

Thursday 1st October 2009
quotequote all
Gerald-TVR said:
Like the dashboard Tom, you, me and about 38 other cars had one with that finish
Yeah the walnut dash is lick

probably not quite as nice as yours though!