Fitting new head gasket set
Discussion
ketvrin said:
Ed
Take a look at the Scorpio engine link in the useful links wiki
V6 engine section and you will see the whole job described very well
Torques, where to apply sealant etc etc
I'll know on friday if I need to do mine...
Fingers crossed I'll not
Good luck
K
um sorry how do I get there?Take a look at the Scorpio engine link in the useful links wiki
V6 engine section and you will see the whole job described very well
Torques, where to apply sealant etc etc
I'll know on friday if I need to do mine...
Fingers crossed I'll not
Good luck
K

Ragtop said:
Looks like 2.9 EFI is the picture - not same as me (2.8i) does this matter do you think?Sorry again Ed I didnt notice you had a 2.8... but for your original question its the same ... i.e. dry
but ignore the torques and sequences on there in case they are different as I believe the 2.8 re-uses head bolts and does not use the Torx (stretch) bolts so they will be different.
sorry for any confusion I caused mate
K
but ignore the torques and sequences on there in case they are different as I believe the 2.8 re-uses head bolts and does not use the Torx (stretch) bolts so they will be different.
sorry for any confusion I caused mate
K

Gassing Station | S Series | Top of Page | What's New | My Stuff



