outrigger seat belt bracket dimensions

[chiefyo]

Hello
I am currently progressing with chassis refurb on my S3C and have successfully replaced my outriggers. I now need to fit new seat belt brackets to both outriggers, however there was not a lot left of my origanals to take dimensions from. So the request is can anyone provide dimensions for the said brackets.
Many Thanks

[tinks v8S]

YHM i have my old 1 still

[chiefyo]

Still need help on this if poss. Had a good conversation with tinks but he didn't have what I needed. Just to try and clarify the bracket I need help with is the very small ones mounted about 6 inch from the rear on the outrigger tubes. But thanks again to tinks for his offer of help.

[tvrgit]

I'm just doing a partial lift at the moment - only a few bolts to go, hope to be lifting the body on saturday. The seat belt bolts are out and the brackets are still in one piece so if you don't get anything before then, I'd be glad to take measurements for you.

[TonupS2]

I can measure mine if it helps I assume you are referring to the fixing points on the outer most tubes. Welded inverted 'U' brackets?
Tony

[chiefyo]

Hello Thanks for offer. Thats exactly what I need as you describe inverted U. Probably the most critical dimension i need would be height from top of tube to top of bracket, any more detail would be a bonus.
Many thanks Dave

[TonupS2]

Photos and dimensions of seat beat mount.

[chiefyo]

Absolutely perfect just what I needed.
Many Thanks. Dave.O

[phillpot]

Don't forget seat belt bolts are still imperial (7/16 UNF) not metric !

[Barkychoc]

You need all metal 7/16 UNF self locking nuts for those, preferablly not galv as the zinc makes poisonous fumes when you weld it.