steering cowl s2

[thinbo 1]

anyone know where to get the plastic cowl from underneath the steering wheel?as mine fell of going over pot hole,looks like its been damaged in the past and has now fell to bits around the bit where its supposed to click! into place.
cheers.

[Barkychoc]

There should be a screw holding it on at the steering wheel end.

[Gerald-TVR]

Three screws

[mep12345]

Funny, Only 1 screw on mine and mine doesn't have the "column adjust" hole it is solid

[thinbo 1]

thanks.the screw holes have been broken and glued back together in the past,will try ford dealers for anew one?

[Gerald-TVR]

Upper - FINIS Code 6155169 Part No.83-BB-3533-BAW

Lower - FINIS Code 6155171 Part No.83-BB-3530-BAW

[ketvrin]

like this ?

http://cgi.ebay.co.uk/NEW-GENUINE-FORD-SIERRA-P100...

must admit, like Mark, mine has only one screw and no large aperture - but mines an S3 ???

HTH

K

[Gerald-TVR]

Thats the one I suspect that Marks and Kevins are the same but covered in vinyl so only the one screw hole is seen and the big hole (which is for boot release on earlier cars) is covered

[mep12345]

Gerald-TVR said:

Thats the one I suspect that Marks and Kevins are the same but covered in vinyl so only the one screw hole is seen and the big hole (which is for boot release on earlier cars) is covered

Nope had mine off numerous times - no big hole and solid plastic inside

[Barkychoc]

Just beware - I don't know what / if there is a difference but that ebay ad says left hand drive (L/H/D in ad).

[phillpot]

Two screws in mine (early S3) but you have to "feel around" for the slits in the vinyl, stuck on by TVR not original Ford, to find them.

[ketvrin]

Barkychoc said:

Just beware - I don't know what / if there is a difference but that ebay ad says left hand drive (L/H/D in ad).

I must admit I missed that but suspect they are symmetrical... anyway send him your reg number and he'll check the details for you !!!

I'm pretty sure that mines solid behind the vinyl too with no hole...

K