red wrinkle powder coaters

[gsd2000]

Ive got some valve covers which i would like powder coating in a wrinkle red finish and was wondering if anyone knew of any good powder coaters who could this.

Ive emailed one in Worcester and Redditch, but looking for other suggestions.

The closer to Derby the better

thanks

[JMP86]

Can reccomend redditch shot blasting,

[russell_ram]

JMP86 said:

Can reccomend redditch shot blasting,

x 2

Russ

[gsd2000]

Anywhere else?

[robdcfc]

There's a few coaters around Derby

Millennium coatings in Ripley
Might even get the wheel specialist in Nottingham to sort it?


Rob

[gsd2000]

robdcfc said:

There's a few coaters around Derby

Millennium coatings in Ripley
Might even get the wheel specialist in Nottingham to sort it?


Rob

but ive tried a few in derby and none do that finish in particular thats the tricky part

[Vulgar LS2]

I might be being a bit thick, but what is wrinkle finish?

[Blair357ci]

Redditch powder coaters only when we had Craig's & Chancy's done everybody f**ked them up.

[ciderminx]

Do you mean like this?

Edited by ciderminx on Friday 18th January 22:04

[ciderminx]

Do you mean like this?

Edited by ciderminx on Friday 18th January 22:05

[gsd2000]

ciderminx said:

Do you mean like this?

Edited by ciderminx on Friday 18th January 22:04

yep, got some of the paint from frosts but to get a good finish i need a big oven which i dont have

[ciderminx]

Done ours on a bench with a heat gun, then left it to dry on our dining room table! An oven finish can make the crackle go too flat. The secret is 3 coats, five minutes apart, different directions, then heat it. Et voila!

[bionicjim]

You could try project powder coating and wheel finishing
In lye near Stourbridge he did my wheels

[gsd2000]

ciderminx said:

Done ours on a bench with a heat gun, then left it to dry on our dining room table! An oven finish can make the crackle go too flat. The secret is 3 coats, five minutes apart, different directions, then heat it. Et voila!

suppose its worth a shot as ive got the paint, did you use a primer?

[ciderminx]

Not primed as such, but the aluminium was etched before painting.

[Ratt]

http://www.powdercoated-customcarparts.co.uk/crink...

Maldon Shotblasting and Powder Coating (if you want it done right) or you could use some of the other methods mentioned (as creative as they sound).