Help!! I need a picture of this.....................
Discussion
Hi guys, I removed the throttle linkage/plates this evening to clean and paint them. Everything's fine but now I have put it all back together I have one spring which i cannot figure how it fits.
Does anyone have a nice clear picture of the throttle cable end/ mounting plates/ linkage etc so I can see how it all looks?
The spring I'm not sure about is the broad squat one, not the long narrow one that fits near the cable itself. I think this one fits inside the plates nearer the plenum?
Jimbo
Does anyone have a nice clear picture of the throttle cable end/ mounting plates/ linkage etc so I can see how it all looks?
The spring I'm not sure about is the broad squat one, not the long narrow one that fits near the cable itself. I think this one fits inside the plates nearer the plenum?
Jimbo
Gassing Station | Wedges | Top of Page | What's New | My Stuff





..I could pop over..(It wont take that long to get there this time of night)..and you could do my wheel bearings..Ill turn off the engine as i enter the road and coast it to the ramp..When its done i can push it to the end of the road and start it as not to wake the neighbourhood.. 

