350 Relay Board

[mikanel]

Putting the Wedge back together after new carpets, I would like to mount the relay board correctly and replace the tie wraps it was previously hanging from, can anyone advise how it is supposed to fit please, there are 4 plastic mountings on the plate fixed to the bulkhead (which also has the hinge for the ECU trim) but these do not appear to fit the back of the relay board.

Thanks Mike

[TVRleigh_BBWR]

The Original design was very poor, that put a bit of ply or hard cardboard in the but of carpet to make it stiff, which then just slotted into the dash, and the stiffness should have held it there, but they all sagged in the middle and would fall out.

[vampire222]

Funny, mine is in the back of the glovebox, behind a panel you can take off there. Was a b*tch to find its a nice location though.