Wheel Rims - what other non-OZ car rims could fit a 450SE!

[hueb]

Hello all.
I've a set of 225-50-15 semi-slick tyres that I want to fit to some 'mainstream car' rims. The Oz Racing wheel rims I currently have on the 450 are 15", 5-114.3 with an offset of positive 20mm (ish) and bore is 63.3mm. Bearing in mind I'm located in sunny Australia, the nearest rims I can find here to fit are likely from Jap cars. The Honda CRV/HRV wheels get closest with positive offset 40mm, bore 64.1mm so I'm guessing hub spacers then required. Has anyone else found another car whose rims are a close match?

[Rockettvr]

Hi
I have done a little research into this and found a website : Wheelfitment.eu that lists all major car makers wheel sizes ofsets and centre bore size. Sadly there is no direct swap on there but a few (mainly Audi& merc)that could be adapted to fit. Good luck

[Rockettvr]

Sorry just took another look its mainly honda stuff youll be looking at -but all the ofsets are bigger.

[barrington]

17 inch oz mercedes stud pattern and offset i had spacers made (yhm)

[Rockettvr]

I'm not that "up" on all the changes that happened during the model changes of the wedge but i think std wheel fitment of the granada and the earlier/smaller wedges was 5x112 63.4 ctr bore 38mm offset. I,m also led to believe offset + or - 5mm is ok ? hope this helps

[al 350i]

you could try looking through this list, then its onto ebay

http://www.carlsalter.com/wheel_fitments.html

[simboy1973]

I had 17 azevs on my old 390. They were Mk2 Granada fitment which I believe is also merc..
You want some thing with a deep dish not a flat faced alloy to look right.

S