New Air Cleaner Just Fits!

[Mr WST]

Bit of a gamble with the fit though it clears by a mm (well i can close the bonnet).
Forgot about the VAT charge at customs though !
This country

Thack

[mrzigazaga]

Hi Mate..The only thing i would be slightly concerned about is that it sits over the engine and would probably be pulling in warm/hot air....I think i would of opted for a bonnet scoop to feed the original pan, Especially as it was going to be painted anyway..Looks mental..
http://www.google.co.uk/imgres?q=bonnet+scoops&amp...

It certainly sucks how they jump on you for not paying tax..Even when you buy it in a different country which makes no sense whatsoever...

Edited by mrzigazaga on Wednesday 31st October 16:39

Edited by mrzigazaga on Wednesday 31st October 16:40

[Mr WST]

Probs get an air feed from the front or the vents at some point. Its got to be better than the other filter sat on the carb. 2 now sucking air in

Thack

[mrzigazaga]

The Holley hi-tek air cleaner is a new bit of kit that offers good rates of air induction and are meant for high manifolds..There is a possibilty that the lower half will draw in hot air from the manifolds and the top part will be near to touching the bonnet..In essence its good to have a good flow of air and at the right temperature...Cold air feed will help...Here is a little calculation to help give the correct air flow figures...Your cu.in is in the second link..Your max rpm is probably around 5000-6000..
http://www.google.co.uk/url?sa=t&rct=j&q=c...

SD1 info;
http://www.google.co.uk/url?sa=t&rct=j&q=c...