Sprintex supercharger belts.

[mrzigazaga]

Hi Peeps...Just wondering if anyone knows where to get Sprintex S102 drive belts as i cant find any?..Need a spare as you never know...Cheers...Ziga

[Transmitter Man]

Zig,

If you cannot find a source sift through:

http://www.ebay.co.uk/sch/i.html?_trksid=p5039.m57...

Maybe contact some of the advertisers.

Phil
420 SEAC

[mrzigazaga]

Cheers phil...Ziga

[adam quantrill]

I use a distributor called "East Anglia Bearing Services" in Ippy but any decent parts supplier should be able to get them. I expect you have the toothed pulleys? In which case an NNNNx8Mx30 where NNNN is a number - length in mm. E.g. mine is a 1360X8MX30, i's an M8 x 30 belt length 1m36. The 8 is 8mm between ribs (for Delilah's pleasure) and the 30 is the width in mm.

You need to put some string around your pulleys (including the idler pulley) where the belt goes to measure the length, then take off a little bit so you can tension it.

The next most important thing is to buy a decent one or else it will snap. I have tried Pix belts but they aren't up to the strain, I am currently on a Gates Powergrip HTD.

[Oz2]

Sprintex is based here in Australia now I think WA.
Adam

[adam quantrill]

Have you tried contacting them? I have - never had an answer in 7 years.

[mrzigazaga]

Cheers chaps...I do have some numbers on mine which were..K168 and a bit further along was BEB2?..Not sure what that means and had no joy inputting it into groogle..I will have a measure tomorrow...I know that a fifth gen of screw sprintex S/C's are being made at sprintex Australia and i was going to email them to see if they can also advise..Cheers...Ziga

[adam quantrill]

Good luck with that one.

Zig - post up some pics of your supercharger and crank pulleys, with a ruler in there for scale.

Also check out: SX technical Data