where do these go?

[marcus1875]

Stuck with the following three pieces for the interior, any ideas where they fit?

[mrzigazaga]

marcus1875 said:

Stuck with the following three pieces for the interior, any ideas where they fit?

Hi Mate..Those bits go under the dash..drivers side left knee and passengers right knee..Not sure about the other bit though...Cheers...ziga

[Number 7]

The top one looks like the section between the lower dashboard and the transmission tunnel - not sure which side though. The strip in the middle (assuming it's steel with or without a veneer face) bolts horizontally to the door panel. Can't make out the last one.

[marcus1875]

cheers guys.
i thought the top pic went there, left leg of driver but cant see how.
the middle pic is about three foot long with screws every foot or so. dont see how it would fit a door card as they are all in place and look conplete. it seems too short for anything other than perhaps a finish for headlining (i've a fhc).
the third pic is a piece of fibreglass about a foot and half long, a eigth thick and four wide. one hole for a screw at on end. no idea!
cheers
marcus

[Wedg1e]

Where do you have gaps?

I agree that pic 1 looks like the heater duct trim from the driver's side of the tunnel: on my car the end nearest the firewall has a screw through it and the carpet into the side of the tunnel, the other end just tucks in behind the side of the radio console.
I have a feeling that the 18 x 4 inch bit is the same trim from the passenger side of the tunnel and is bodged fitted in the same way.
The three foot (bit of wood?) is perhaps something from the rear end of the cabin, where the spare wheel fits?