Plenum hose

[TVRIK]

Hi guys I'm gonna order a nice shiney red hose, the main elbow hose from plenum,
What is the exact size I should order?

Rik

[mrzigazaga]

Hi Mate...I believe its 68mmID..If you can pull the existing one off and either measure the AFM opening or the plenum inlet to be sure...Be careful when you order an elbow as the plenum end is longer than the AFM end and i think its longer than a standard elbow..Im sure ACT can provide the correct one....Cheers...Ziga

[TVRIK]

mrzigazaga said:

Hi Mate...I believe its 68mmID..If you can pull the existing one off and either measure the AFM opening or the plenum inlet to be sure...Be careful when you order an elbow as the plenum end is longer than the AFM end and i think its longer than a standard elbow..Im sure ACT can provide the correct one....Cheers...Ziga

As always Zig cheers, if you charged for your time, you would be a wealthy man!

Thanks pal

Rik

[mrzigazaga]

TVRIK said:

As always Zig cheers, if you charged for your time, you would be a wealthy man!

Thanks pal

Rik

[maston]

tvrik, not sure zig is right, do check as I think the ID is 72mm.
Well, it is on mine anyway.....

[dixiebabes]

Phone ACT he couldn't do enough to help round about 40 notes if I remember correctly.

Dix

[Convert]

Yup, I got mine from Tim @ ACT, brilliant service.

[adam quantrill]

72mm does ring a bell but measure both ends and chose the smaller.

[matt-man]

Yup, act...be careful when you fit though...I cut, checked, cut, checked, cut checked...oh ste, too much!!

[TVRIK]

Nice one guys... Mines taped up at the moment so bound to be the odd leak, will that have any effect on the performance?

[carob]

72mm is the correct bore. To cut mine when I marked up and put it in a vice, this held it still whilst cutting with a sharp hacksaw, using the jaws of the vice as a straight edge. First time spot on.

Rob

Edited by carob on Sunday 16th March 07:31