ARB clamp

[TVRleigh_BBWR]

Anyone got one, or know where to get one, seem to be one missing

[adam quantrill]

Leigh I started looking into these a few months ago when there was a similar post. Seems the old ford ones are no longer made but I think I found a Merc Sprinter might be a near match. You need to take the other one down your factors and do some comparisons. You may have to fettle the clamp lug a bit to make it fit. Please let us all know if you find a match.

[pistolar]

You need to look at the sexy Lotus Elise / VX220 alloy brackets

[KKson]

Leigh, I fitted two new ones at the weekend. I got them off eB including poly bushes. Mine's got a 25mm roll bar and they fit perfectly and with the silicon grease they are sweat and silent. Highly recommended. Link below.

http://www.ebay.co.uk/itm/151274353763?ssPageName=...

I've got the two old ones off mine here but they are not a matching set and I do not believe they are correct for the bushes as I could never get them right. Forum topic below includes a picture of the old brackets. If you think one of them matches yours then you're welcome to it.

http://www.pistonheads.co.uk/gassing/topic.asp?h=0...

[adam quantrill]

Kieth - I just saw your post on that old topic - red sealant would have done!

Yeah the "two bolt" ARB brackets can be used - you have to drill out the other hole of course. But they should last much longer than the original Ford ones because they are secured in two places - the Ford ones tend to disintegrate around the small tab.

[KKson]

The new brackets fitted without any drilling or mods as holes all lined up fine. Leigh if you want either of the old brackets then let me know.

[adam quantrill]

Ahh yeah that's because in your case someone had already drilled out for the modified ones you took off, if you are still on original Ford then one side is a hole, and the other side is a slot.

[KKson]

Adam, on mine top is a circular hole and bottom is square slot but bolts fit through okay. Was the original just a narrow slot? If so then one of my old brackets is okay for this fitment.

[TVRleigh_BBWR]

Let me take the one left off, and post a pic.

[dixiebabes]

Leigh I think I have the original ones off my series 1 you can have tem if I can find them when I get back from offshore. PM me with your address if you want them and ill post them out for you.

Dix