Back pipe

[stevoj]

Anyone have knowledge of best place and cost of a back pipe for 390se. st/st preferable.

The pipe i think is standard, runs along back of car and then hoops over n/side drive shaft before going forward to join center box with flange fitting.

Thanks.

[Jack Valiant]

Tim at ACT will sort you out ... not the cheapest but its good quality stuff

Chris

[ElvisWedgely]

Pipecraft in Basildon can make one and fit it for you. I've used them before and they are very good and friendly. Though I think they may be a bit too far for you. Surely there must be a custom exhaust fabricator in your area.

Tony.TCB.

[JVaughan]

My system was made by Powerflow.

[wildoliver]

Is it the same as a 350i part? I ask as my 350 which I'm doing a lot of work to modifying as I rebuild it has a stainless box that runs from the centre of the car to the rear, where a tailpipe bolts up to to it to complete the last bit of the puzzle.

Most of my system is totally pear rotten, in fact most of it has dropped off already, the headers are missing the lower few inches even! But that stainless box is good, I'm not going to use as I'm going to build my own system with twin pipes all the way down.

[jindle]

For no good reason other than the car was just up on a lift thought I'd post a picture of my exhaust. No idea who made it.

[stevoj]

Thanks guys, my middle sections is st/st and the back pipe is mild steel and have found a small hole in it but nothing that won't wait so was hoping to get something more off the shelf rather than custom made but plenty options to go at which ever way takes.
No costs posted up but i would guess for a pipe in st/st we are still looking at +£150

[adam quantrill]

PD Gough if Nottingham isn't too far.