Discussion
wooly350i said:
Wedg1e does em.
My wedge is a donor car for his bits now.
My wedge is a donor car for his bits now.
Rimmer Bros do the original type rubbery plastic bush if you're so inclined, costs not a lot but guaranteed to wear out faster than Gary Glitter's welcome.
You can buy off-the-shelf self-aligning bearings which are a better bet, you may have to make/ buy a bush to match the bore of the bearing with the outside diameter of the steering column though.
Couple of pics here:
http://www.wedgeneering.co.uk/TVR%20390SE%20p10.ht...
I know a couple of other folk on here have done the same mod. (in fact I'm not the first to document it, there was a feature on TVRWedgePages but I think that's offline nowadays), they may be able to point you in the direction of the particular parts they used, I got mine from a local bearing supplier based on a sketch I had in my pocket at the time so I didn't get an invoice with part numbers etc... I think it was a 17mm bore bearing with integral rubber seals both sides and the column is 9/16" or 14mm, but it was a few years back.
Gassing Station | Wedges | Top of Page | What's New | My Stuff