Combined pot and pump unit

[uglymug]

hi , does anyone know if they make a 300bhp version, or anyone else makes these ?


http://www.ebay.co.uk/itm/WEBCON-WFP600-EFI-FUEL-P...

[TVRleigh_BBWR]

any reason you want them combined ?
I've got a full systec system on the racer that is rated to over 350 BHP.
RedTop to Sytec swirl port, then pre-filter, then pump, then injection filter.

[uglymug]

hi, no reason at all, seemed a good neat unit. like your setup. do you have more details of part numbers/cost ..........thanks

[TVRleigh_BBWR]

will sort out the numbers.
you may want to use the stand swirl pot as its hard to fit any others in the space.
On the racer I only have one tank so I was able to put in a bigger swirl pot.
best not to rely on the swirl pot filter and use an external one designed for injection pumps.


alternative swirl pot CCP001
Pre-Filter BULLETA6-B (12mm-12mm) check on swirl pot and pump size.
Your need High Flow Metal Filter Element For Sytec Bullet Filters for above (BULLA02)
injection filter SSFC5160C
and depending on flow your need an OTP017,OTP018,OTP019,OTP020 or OTP044
if you use any above the lowest power OPT017 you need to get extra ends for the banjo fitting.
If you use the OP044 you can swap all the above for JIC fitting, but will add to the cost.
you should be able to find the bracket I use on ebay.

Also worth getting some Anti-Vibration Foam Sleeve For Walbro & Sytec Pumps

oh and don't use cheap injection hose, make sure it's compatible with unleaded fuel, else it will break down, and get into the pump.

I got all mine from demontweaks as I get motorsport discount, so works out about the same as most of the others.
I used to get from a guy in wales, but he was got too busy to take my calls.

Edited by TVRleigh_BBWR on Wednesday 15th June 12:46

[adam quantrill]

Don't use a paper element in your pre-filter either, 75 to 100 micron mesh.

[TVRleigh_BBWR]

adam quantrill said:

Don't use a paper element in your pre-filter either, 75 to 100 micron mesh.

I did put that under the bullet filter part BULLA02 and is a 50 micro metal mesh and designed for use before the pump.
you can use them with the paper filter after, but prefer to use the other style and replace every few years.
but as adam says best make sure as they come standard with a paper element, its an easy swap though.